maizey Posted August 4, 2023 Report Share Posted August 4, 2023 Noticed that the headlights had taken a bit of a beating after June's hot days. Didn’t fancy doing all that sandpapering work so used the Turtle wax headlight cleaner and sealant. Did this by hand: Spent about 15 mins on each headlight using a micro fibre cloth wrapped around a scotch bright pad, just to give it a bit of firmness. Quite happy with half an hour’s work and one less reason for the nasty MOT man to pick at. As this is an abrasive just take care of the surrounding paintwork. For comparison - 1st photo shows drivers side done and passenger side untouched. (Apologies if this has been covered previously). 2 Link to comment Share on other sites More sharing options...
CheltGirl Posted August 4, 2023 Report Share Posted August 4, 2023 Always good to hear of different methods to tackle this annoying problem. The MOT chap failed our old Rav on one occasion because of the cloudy headlights. Trouble is, it happens so gradually you sometimes don't notice!! Link to comment Share on other sites More sharing options...
77 Liftback Posted August 4, 2023 Report Share Posted August 4, 2023 Good work Need to do my daily , good to know the Turtle Wax works well Link to comment Share on other sites More sharing options...
slybunda Posted August 11, 2023 Report Share Posted August 11, 2023 Thanks will get a bottle of that stuff Link to comment Share on other sites More sharing options...
A Pair Of Flabby Wings Posted August 15, 2023 Report Share Posted August 15, 2023 Yes, I've got an old bottle of Plast-RX that has worked well, but it is nearly ten years old and could probably do with replacing. I'd recommend a polishing mop on the end of an electric drill to enable you to do more with less effort. Do put a couple of layers of masking tape around the edges though. It takes five minutes to do, but, as others know, it can save you heartache. Link to comment Share on other sites More sharing options...
benjia Posted August 15, 2023 Report Share Posted August 15, 2023 I have a Makita DPV300Z that I use for this job - makes light work of it! Link to comment Share on other sites More sharing options...
gt4_ade Posted August 16, 2023 Report Share Posted August 16, 2023 Best off sanding with 6-800 wet n dry, work up to 3000 and clear coat. This way you will never have to buff again Link to comment Share on other sites More sharing options...
bazz54 Posted August 16, 2023 Report Share Posted August 16, 2023 Interesting, certainly looks like it works but hard to know how well the sealant will work. Link to comment Share on other sites More sharing options...
Recommended Posts