Biggy
-
Posts
6,738 -
Joined
-
Last visited
-
Days Won
2
Content Type
Profiles
Forums
Events
Gallery
Club Shop
Collections
Everything posted by Biggy
-
Not sure where you are ,but i have a 3 post in grey if it helps..
-
Mine are steel and anodised...As said avoid ally nuts..
-
I think black would look fine IMO..
-
Maybe don't go chrome again ?? After all it's not the 1980's
-
I have black anodised ones on mine and there still good..
-
I got one that was quite slim of ebay..
-
can you fit a slimmer fan maybe?
-
Could be 3sfe engine..
-
Any thing corroded i use a wire brush in a drill..can get lots of different sizes.. Where are the wheels from? The 80,s
-
Good question..can you use it on bare metal and also painted surfaces?
-
you shouldn't need primer ,as long as it's flatted well..any bare metal should be primed..
-
It would be laquered,I doubt spray cans would get you a good finish,also you will have matching in issues with the other panels...
-
Roll on the next car
-
I say make Dave pay
-
Aren't some tuner nuts ally,which are to be avoided?
-
Fox R5 ? http://www.google.co.uk/imgres?um=1&hl=en&sa=N&tbo=d&biw=1366&bih=643&tbm=isch&tbnid=1pOJVfr0sAUUNM:&imgrefurl=http://www.ronniecowan.co.uk/Fox%2520Alloys%2520page.html&docid=TaWtTZOKg1vxOM&imgurl=http://www.ronniecowan.co.uk/Fox061.jpg&w=1008&h=1313&ei=rJX6UL2NBLCp0AW_v4HgDA&zoom=1&iact=hc&vpx=1128&vpy=270&dur=106&hovh=256&hovw=197&tx=132&ty=98&sig=114796051953265826610&page=2&tbnh=141&tbnw=112&start=24&ndsp=33&ved=1t:429,r:31,s:0,i:234
-
where from Rich?
-
I did see that I would be careful doing it with a breeze block,seen it done years ago and the block got ejected from the wheel and smashed the sill...
-
Your car isn't lowered is it?My car wouldn't drive up to breeze blocks without hitting the front bumper..
-
Shouldn't really be under the car with no stand in the first place..if you are placing a axle stand under the car,leave the wheels on so atleast it would save you if your arm was just reaching under and the jack collapsed.... 4 wheels would be better mate IMO..
-
Why Bryan?your not lifting the complete car of the ground?The roller on the one i have can be awkward on uneven ground and make the jack a bit wobbly
-
I have the last one in the pics,very light jack, only prob i have had is the bolts seem to come loose,but i'm sure thread lock would help..
-
the rear long bolt's that go through the outer bushes can be a problem...bolt gets stuck.
-
Try this link.. http://www.gt4-racing.eu/index.php/toyota-celica-st202
-
As above,wrong gen celica to be a hairdresser's car :xmas_laugh: