The Blue Meenie Posted October 3, 2012 Report Share Posted October 3, 2012 Blu's developed the dreaded rusting on bottom off Gen 6 doors (due to previous owners not checking that the drain holes were blocked) Been looking at the follow, and wondered if any one has used them in the past... and has the doors stayed rust free... rust remover http://www.bilthamber.com/corrosion-treatments/deox-gel top coat prior to paint http://www.bilthamber.com/corrosion-treatments/hydrate-80 i'd take the door card off and do it inside too if you can see rust if not just use the cavity wax Or if you can get it totally rust free which in the area it is i doubt it: http://www.bilthamber.com/paints-and-coatings/electrox cavity wax http://www.bilthamber.com/cavity-waxes/dynax-s50 Link to comment Share on other sites More sharing options...
ams Posted October 3, 2012 Report Share Posted October 3, 2012 used to use ku-rust when I had a metro - did a good job and stopping it dpreading Link to comment Share on other sites More sharing options...
thermoacc Posted October 3, 2012 Report Share Posted October 3, 2012 I use the bilt hamber clay bar. Best on the market. I would trust it to work as they have a good rep. But as listed above kurust, jenolite and hammerite rust treatment are all good. I used to be into 80's Fords....so i know! Link to comment Share on other sites More sharing options...
Razorjack Posted October 5, 2012 Report Share Posted October 5, 2012 I soaked most of the Nova in Kurust, then a couple coats of hammerite. Works really well. Link to comment Share on other sites More sharing options...
The Blue Meenie Posted October 5, 2012 Author Report Share Posted October 5, 2012 Thanks guys... will look up kurust and jenolite Link to comment Share on other sites More sharing options...
Recommended Posts