zajc3w
-
Posts
303 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Club Shop
Collections
Everything posted by zajc3w
-
To mentioned guide i would add some paint on the rivetnut before inserting/crimping to stop corrosion. I've used etch undercoat(ott, hammerite will do), just painted rivetnut, after crimping i have nice round paint seal on both sides. P.S original clips are 6mm.
-
Did they use air gun on that key? I'm pretty sure key isn't impact wrench rated. If that's the case garage should pay for new key to remove front locking nuts and for replacement set of locking nuts.
-
Shows why you should insist on use torque wrench when tightening them up. Sadly that eliminates ~70% of garages.
-
^^^^why so short and so thin?^^^^ Avensis discs and pads from freaky.
-
Charge 25% handling fee ;P
-
6.5-8mm plastic clips for my engine undertrays
-
If not starter motor then engine. But something is seized put it in 6th gear an push it. You should be able to turn engine over pretty easy. Looking through spark plug hole is rather pointless without endoscope, can't see cylinder wall.
-
Kdyke 2 black sheep then - I'm 32 electronic engineer, decided to go celica way after 2 years in company gutless fiesta limited to 70mph ,had enough of 30 sec acceleration 50->70. I've seen 3 celicas on the road so far, one on tow truck, another one with too big exhaust barely visible trough dirt, possibly storm grey. Third was my works colleague, 140 pre facelift, 200mpg of oil, has been scrapped about year ago.
-
HI. obd scanner, that will point you in correct direction. Engine light stays orange, red is different cars.
