As above long bolt can be a pain
Was 2 - half days not two and a half lol
But I had use of air tool and a 15 tonne Hydraulic press so makes life easier. Doable without tho.
Decent set of tools, more specialist stuff required will be a torque wrench, axel stands, poss drill and one handed hacksaw ( my pref but other methods can be used) wd40 a must, some m10 stud bar nuts and washers are handy( will explain later) I also needed to replace one of the bolts on the bottom if the rear hub which goes through the trailing arm as needed to be cut. And some paint while u got it to bits.
That all I can think of the the min , may of missed something.
Right tricks to removed without aid of a press
This is the method I find easiest others may disagree or prefer another. This is the chain drill method. U drill round the rubber part of the bush as far out as possible and as close to each other as possible as many times as possible. U then simply knock the middle of the bush out , the with ur hacksaw cut carefully thought the metal outer sleeve then use a small flat screw driver to prise up one end and out.
Tricks to refitting without a press this is where the stud bar comes in handy , pics tell a 1000 word lol
Yes big hammer wd40 works well lol the clean up and refit with lots of copper slip