roy newton Posted November 1, 2012 Report Share Posted November 1, 2012 Is there any way of converting the dlc1 dianostic socket on a gen 6 to work on a obd11 Link to comment Share on other sites More sharing options...
ams Posted November 1, 2012 Report Share Posted November 1, 2012 i very much doubt it - wht do you want to do it? Link to comment Share on other sites More sharing options...
planc Posted November 1, 2012 Report Share Posted November 1, 2012 They do adapters in the states but I would question how much info a OBD tester could read from an older ECU. Link to comment Share on other sites More sharing options...
cooperman Posted November 2, 2012 Report Share Posted November 2, 2012 as far as i know there is only 2 ways around it. to get full OBD2 out of it and thats, 1 buy a new car. 2. change the loom, ecu and engine for a new obd2 engine setup. you have to think of EOBD as being an old analoge signal and the new OBD2 as being a new digital signal. even though alot of tester will read the old EOBD signal it will not be as detailed as the new OBD2 signal. Link to comment Share on other sites More sharing options...
roy newton Posted November 2, 2012 Author Report Share Posted November 2, 2012 as far as i know there is only 2 ways around it. to get full OBD2 out of it and thats, 1 buy a new car. 2. change the loom, ecu and engine for a new obd2 engine setup. you have to think of EOBD as being an old analoge signal and the new OBD2 as being a new digital signal. even though alot of tester will read the old EOBD signal it will not be as detailed as the new OBD2 signal. Thanks Link to comment Share on other sites More sharing options...
Recommended Posts