martinking6
-
Posts
364 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Club Shop
Collections
Everything posted by martinking6
-
Ye no probs, text me your reg please and I will get a quote tomoz 4 ya Martin
-
Hiya manny Spring compressor still needed and prices above are bang on Martin
-
where to get a custom exhaust
martinking6 replied to mattyjones's topic in General Celica Discussion
I make exhausts and am not too far away in blackburn Martin -
Replacing fuel pump -safety question before restarting!
martinking6 replied to digs's topic in General Celica Discussion
Good stuff :-) Martin -
Replacing fuel pump -safety question before restarting!
martinking6 replied to digs's topic in General Celica Discussion
The heat wrap doesnt last long unless you buy the expensive oil/petrol resistant stuff and same goes for your insulated terminals you posted a link to, I use a commercial heat shrink connector thats resistant or where I can I will run new wire with terminals either side so no connectors Martin -
The only way I would flush an engine is with cheap engine oil, I never use diesel, flushes or anything like that, simply fill with a suitable cheap oil and do regular changes its always worked for me Martin
-
Sorry to hear it ya gonna source another engine for her ? Martin
-
Will be fine sai, it makes sense that it smells a little from being constantly stop/start slipped for 3 hrs C ya sunday :-) Martin
-
Anyone used this Red rubber grease?
martinking6 replied to matt1280's topic in General Celica Discussion
I use this grease on all the rubber seals, etc on the rotational inner edge of the cam/crank seals for example and on anything rubber when I am assembling engines, components, etc its great stuff Martin -
Hiya sai I would be very surprised if its burnt out from stop start in traffic, it should be fine was the set offs on a hill or something so needed clutch slip to set off ? Martin
-
Hiya scott Am deffo available to do this if you fancy a drive over Martin
-
The power hood should be on hydraulic fluid which I have at the unit, no point filling it up to leak all over again best just to wait till I fix the leak Martin