shaungt4 Posted November 26, 2012 Report Share Posted November 26, 2012 Morning guys I have bought a remote door locking kit for the gen5 and was wondering if anyone could tell me how to fit it Do i fit it to the central door locking relay box ifso ware is it located and dose anyone know what the colour wires are i tap into thanks very much Finding the relay box is not a prob just the colour of the wires to tap into Link to comment Share on other sites More sharing options...
Devious Posted November 26, 2012 Report Share Posted November 26, 2012 I have no idea but...when you do figure it out, perhaps you could do a guide? Might help others out in the future. Link to comment Share on other sites More sharing options...
shaungt4 Posted November 26, 2012 Author Report Share Posted November 26, 2012 Yea i will put a guide up for it when i fit it. Prob on the weekend when i have more time weather depending of corse I did put a kit on the Calibra i had and was pretty straight fwrd on their so i guess i will figure it out for the g5 Link to comment Share on other sites More sharing options...
Devious Posted November 26, 2012 Report Share Posted November 26, 2012 (edited) If you're a dab hand with it and not a trillion miles away, I'll bring mine to you and you can fix my C. Locking and maybe ill get a kit too. Where did you get your kit mate? Edited November 26, 2012 by Devious Link to comment Share on other sites More sharing options...
shaungt4 Posted November 26, 2012 Author Report Share Posted November 26, 2012 Got it off of ebay Dover is quite away from me, That's ware i got the Calibra from was hell of a drive Link to comment Share on other sites More sharing options...
cooperman Posted November 27, 2012 Report Share Posted November 27, 2012 this should be easy enough to do. i have done it before but was a million years ago now. down by the drives kick panel is all the wires you need. think i just whipped the door card off and traced the wires through. there is also enough room to mount said remote locking box just under the dash there as well. i think i had a nightmare to get the indicators to flash as well though. ended up using a simple 2 in 2 out relay to get it to work on the back of the hazard switch. you dont have to run wires to both doors though. just the drivers will do as that will automatically open the passengers anyway. i have gone over to a cat1 alarm now but if i get a chance i will look and see where the wire for that go and it should be the same. might be able to get a picture for you. andy Link to comment Share on other sites More sharing options...
shaungt4 Posted November 27, 2012 Author Report Share Posted November 27, 2012 Cheers mate Thought it would be pretty straight fwrd Link to comment Share on other sites More sharing options...
dunebug Posted November 27, 2012 Report Share Posted November 27, 2012 any body any idea why my central locking will only work on the pass side 1900 gen 5 Link to comment Share on other sites More sharing options...
Recommended Posts