Jump to content

OSF ABS Sensor for ST182: Part No. 8954220020


Ant2
 Share

Recommended Posts

As a non-engineer I have a problem...garage replaced OSF hub and rogered ABS sensor in the process. Easily done apparently. Replacement 'modified' sensor (from a different Celica type) has now gone bad. What should I do? otherwise the car is perfect. Thanks for your advice. Anthony

Link to comment
Share on other sites

Xanadu. This is really good news. Apologies for delay replying but hospital visits etc. Have ordered Lexus part...Anyway, when you say 'splicing into the loom', is that just splicing onto the connector already there? Any and all other info. will pass on to engineer who will hopefully do the work. Thank you for any further advice. Anthony

 

 

Link to comment
Share on other sites

8 hours ago, Ant2 said:

...when you say 'splicing into the loom', is that just splicing onto the connector already there?

 

Yes, it's not "plug 'n' play", so you will have to remove the connector from the new replacement and use the old one that's on the car now. It was possibly done the same way when the last replacement was fitted, unless you were lucky enough to have matching male/female connectors.

Link to comment
Share on other sites

  • 2 months later...
 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.