Jump to content

TheVDM

Visitors
  • Posts

    121
  • Joined

  • Last visited

Posts posted by TheVDM

  1. Sounds more like to me your starter is stuck and is draining everything to try and spin it over, what state is the battery in? Dorris

    Didn't think of that! The battery was a spare that used to live in the shed with an inverter on it so it's probably not in the best condition but does crank well and holds charge well. A new 005 battery is in the pipeline for later this year so if that is the issue at least it won't add any expense, it'll just shift around my purchasing priorities :lol:

  2. OK... So every now and again I get in the Celica to go for a drive, turn the key past the first and second notch, everything lights up on the dash just as it should. Then when I turn the key to the starter position I get a relay click and everything goes dead! This to me sounds very much like a bad earth on the gearbox.

    If I pop the bonnet and lightly touch the positive terminal (well not the terminal, but the rubber cap that isolates it) the relay clicks and everything is back to normal. :wacko:

    The battery terminals and terminal clamps are clean and have a good connection and the gearbox earth strap doesn't appear to be corroded, although I haven't delved too deep as the gearbox is being changed next week anyway.

    Has anybody else experienced an issue like this on their car (or specifically a 5th Gen Celica), if so what was the cause?

  3. either heat them up, or if not get some proper penetrating oil like plus gas and spray it on a few hours before

    Thank you ams, I didn't think of getting the blow torch out.

    I've just picked my daughter up from nursery so probably won't get a chance now until Sunday. I'll give lots of heat a go and try and break the seal on the nuts. If not I might try drilling them out as I've got a fresh set of nuts ready and waiting.

  4. Hi all, what's the best advice anybody can offer for undoing the bolts that hold the back box on? I've soaked it in a lifetime supply of WD-40, I've knocked it about a bit to release any loose dirt/rust and I cannot for the life of me undo those bloomin' bolts.

    Should I just get the angle grinder out or is there a secret to undoing the bolts?

  5. The synchromesh on my gearbox has been crunching when dropping down into second gear since I bought it. I know that it had been sitting for a few weeks before I bought it. Since I've owned it I've been avoiding/being careful with dropping down into second gear.

    Today I was driving the Celica in auto pilot as it's currently being used as a daily drive as my other car is off the road for MoT work, coming back from my daily errands earlier on I noticed that I'd been dropping down to second gear and it was no longer crunching, so spent the rest of my drive home consciously dropping down to second from 3rd and 4th... It only crunched when I tried dropping to second at 40mph (not my usual driving style), other than that it seems fine.

    Is it possible that the synchromesh isn't actually worn but was just a bit sticky after sitting for a while? I don't know much about the innards of gearboxes so haven't got a clue how they work or if that's possible.

    If it is possible it's just sticky I'm guessing a transmission fluid change will help it out.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.