Gen6 door card
From Wiki
Error creating thumbnail: Unable to save thumbnail to destination
- Firstly remove the triangular tweeter cover by pulling at the top corner. It’s fairly tight so you may need to prise it out.
- Remove the power window control panel by prising up the bottom edge, and disconnect the plugs from the back of it.
- Then remove the fixings from the door panel
- 1 - Two screws with press-on plastic caps.
- 2 - Five screws.
- 3 - Three plastic push in studs.
- 4 - Remove visible screw, remove plastic trim, remove second screw behind.
- Pull the bottom edge out slightly and unplug the red door light.
- The panel is now hanging on the top edge of the door, just lift it off.
silver gt 19:51, 11 May 2007 (BST)
