Gen6 spark plugs

From Wiki
Revision as of 20:35, 27 January 2008 by Richydraper (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Spark Plug Replacement:

  • Remove HT leads from sparkplugs located on the rear side of the engine noting cylinder assignment.
  • Remove plugs from cylinder head
  • Check gap of new plugs using feeler gauge (NGK Spec: 0.8mm although this should be preset)
  • If adjustment is required use a soft faced mallet to adjust. Don’t ever leave feeler gauge in whilst adjusting gap.
  • Smear a small amount of copper grease or molybdenum grease around the threads, avoiding leading 3 threads.
  • Fit plugs into cylinder head and torque to 18Nm (13.3 lb-ft)
  • Refit HT Leads

Recommended NGK plugs for 3S-GE = BKR6EP-82215

Toyota P/N = 90919-01180

Gap is preset

HT Lead Resistance: <25K Ohm PER Lead




Back to Gen 6 Routine Servicing

Back to Gen 6 Maintenance menu