cpfc1234 Posted August 12, 2019 Report Share Posted August 12, 2019 (edited) Hi all, I am putting the engine bay back together after a recent clutch change and I'm not sure (partly due to previous owners modifications) where certian pipes and connections need to go! Could anyone help with the following: Pic 4: What does this attach to? Pic 3: 2 rubbers attached to distributor... seemingly not needed - nothing attaches? Pic 2: Is this where the lambda sensor connects? Pic 1: My sensor does not fit to clip in and has limited cable length Thanks in advance for any help, hoping to get her started again tomorrow! Edited as pics loaded in wrong order! Edited August 12, 2019 by cpfc1234 Link to comment Share on other sites More sharing options...
commandosqueak Posted August 23, 2019 Report Share Posted August 23, 2019 What car is it? What model and gen? Link to comment Share on other sites More sharing options...
cpfc1234 Posted August 27, 2019 Author Report Share Posted August 27, 2019 1996 gen 6 GT St202 Link to comment Share on other sites More sharing options...
slybunda Posted August 29, 2019 Report Share Posted August 29, 2019 That first pic looks like a lambda sensor for exhaust. Link to comment Share on other sites More sharing options...
99GT Posted August 29, 2019 Report Share Posted August 29, 2019 Pic number 4 the large pipe just goes onto the bottom of the intake rubber if I'm thinking right Link to comment Share on other sites More sharing options...
Monkey Boy 1 Posted August 29, 2019 Report Share Posted August 29, 2019 2nd pic is the cable to the oil level sensor in the sump Link to comment Share on other sites More sharing options...
Alistair_GT Posted August 30, 2019 Report Share Posted August 30, 2019 Pic 4: Bottom of the air intake hose (between throttle body and airbox) there is a metal hose connector. Pic 3: Vent/breathers..not attached to anything. Pic 2: Nope. That plug is for the aircon pump (not connected if car has no AC) Pic 1: Lambda sensor. The plug for it is high up at the back of the engine. Screw it into the hole in the exhaust downpipe, then look directly above. The plug should be attached to a small bracket (stops the cable dropping onto the hot exhaust) Link to comment Share on other sites More sharing options...
cpfc1234 Posted September 1, 2019 Author Report Share Posted September 1, 2019 Thanks for your help! 1 Link to comment Share on other sites More sharing options...
Recommended Posts