Tomb

100% a scam, if you ever see any like this and doubt them check there other items they often have sought after cars at the moment such as a golf R for a few grand, they copy adds from other sites or areas on Facebook, don’t even change the wording as shown by 77 Liftback

Only private collection I’ve viewed where the owner keeps a whiteboard behind ear car (40+) to ensure they all get used frequently enough

The red one to the right is a 2000gt one of two in the uk

Not (my) Celica but I thought this would get appreciation here due to the other car this person owns to the right.

I Just wish mine was facing the same way as the others in this shot

You should be able to get it printed, I designed a mould for my custom intake manifold using a 3D printer. As I only needed the ends mating nicely I used a scanner with rule (for scale) to get the correct alignment. Then worked some carbon wizardy with the mould. if you’re on Facebook 3dprintmyride is full of people that do just what you’re after some have access to CMM’s, although I’ve not used mine for car parts they will give a very accurate measurement of your other side which can be flipped on cad easily enough prior to printing.

New challenge time?

Good job, I may have to copy you in the future are those washer jets on your bumper?

Good work, I look forward to seeing how they appear fitted

Fabricated some brackets for my charge set up; fitted a shorter aux belt so I could eventually removed my ac compressor, and painted my sump.

I count that as achieved

After finding a small amount of fluid yesterday that didn’t appear to be engine oil, spent ‘some time’ last night and this morning investigating. Found it to be an air con leak already small amount of oil? In the pipes as I had lost the gas whilst I had everything apart I decided removed the pipework and rad. Sorry I didn’t want to drive until I knew what it was so missed New Forest @Akuma77

Not what I was expecting to find when checking my rear callipers

My S/C

Next challenge, your Celica with a Deer, keeping it festive

Thanks for the reminder Debs, I aim to be altering it again in the next few weeks > SC <

Eventually got around to fitting Black Betty’s old intake manifold after degreasing it, to replace the dented one I had; gave the rad another bleed; cleaned the throttle body; and cleaned my IACV.

Changed my lift bolts (I was surprised to see wear on them; changed the rocker cover gasket; oil breather upper gasket; oil pick up o ring; changed the plugs; transmission oil change; engine oil change; new oil filter; flushed my rad and matrix before refilling the system; replaced a small section of exhaust to replace a very rusty weld.

Maybe best a photo of him in his ccuk hoody instead then.

In my opinion we need to get Ian and Dean within the calendar, to show the club is also about the people. (Sorry this is taken from the meeting thread so low res, I am sure Cipprio has a higher quality copy of it available).

How about a Noble?