Jump to content

Plastic Underbonnet Trim Clips


davouk

Recommended Posts

Hi all,

Sure it's been asked before so apologies if I'm like a broken record...

Off the top of your heads, can somebody tell me the diameter of the clips used to secure the plastic covers in the engine bay please?

I have several missing.

Cheers,

Dave.

Link to comment
Share on other sites

To mentioned guide i would add some paint on the rivetnut before inserting/crimping to stop corrosion.

I've used etch undercoat(ott, hammerite will do), just painted rivetnut, after crimping i have nice round paint seal on both sides.

P.S original clips are 6mm.

Edited by zajc3w
  • Like 1
Link to comment
Share on other sites

the undertray clips i got were 7mm ones i believe.


i used these ones which are to fit a 7mm dia hole, http://www.ebay.co.uk/itm/TOYOTA-WHEEL-ARCH-INNER-LINING-SPLASHGUARD-ENGINE-UNDER-TRAY-TRIM-CLIPS-COVER-/190818319990?pt=LH_DefaultDomain_3&fits=Car+Make%3AToyota&hash=item2c6da87e76

i did order some 8mm ones but they too big to fit.

  • Like 2
Link to comment
Share on other sites

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.