tombrady Posted October 21, 2012 Report Share Posted October 21, 2012 Has anyone here had any sent off to be done? If so what was it and how much did it cost please? If anyone is interested in getting parts dipped I maybe doing this myself in the near future. Id say to start with it will have to be limited sizes due to having a small tank, eg interior parts etc. Ill post photos once ive done a few and if there is enough of a market and margin ill go Corporate maybe? Cheers! Link to comment Share on other sites More sharing options...
GreyRacer Posted October 21, 2012 Report Share Posted October 21, 2012 My rifles are done by Hydrographics in York. Could not trust anyone else. I had my bonnet scoop done in gloss carbon more than three years ago. £30. Good luck with your venture. I'm sure sh3p was trying the same thing. Link to comment Share on other sites More sharing options...
tombrady Posted October 21, 2012 Author Report Share Posted October 21, 2012 Cheers mate, yeah i see rifles are popular and also game consoles too. Ill see how it goes with some test pieces. Link to comment Share on other sites More sharing options...
Cleario Posted October 21, 2012 Report Share Posted October 21, 2012 My friend has had his whole engine bay bits Done for his st170focus and another had wheels and engine plastics done on hi golf...both very impressive! I'm tempted with my engine plastics, wicked coatings done both Link to comment Share on other sites More sharing options...
yorkie Posted October 29, 2012 Report Share Posted October 29, 2012 i was thinking of this one of the lads in york used to work it that place he had engine bits and intorior bits done in smarties print! looked great! Link to comment Share on other sites More sharing options...
tombrady Posted October 29, 2012 Author Report Share Posted October 29, 2012 Well ill probably be tackling some after christmas and see how i get on Link to comment Share on other sites More sharing options...
Recommended Posts